Lenoxx Electronics PH5435 - Manual (Page 7)

IB-PH5435-WC-E-032805
Before you connect the phone cords, follow these steps to install
the batteries:
1. Push down the battery door tab with a pen or other pointed
object and lift the battery door out (Fig. 1).
2. Insert 3 size “AA” alkaline batteries as shown inside the
battery compartment (Fig. 2 & Fig. 3). (The negative side (–) of
the battery touches the battery spring.)
3. Replace the battery door and snap it shut (Fig. 4).
• When the batteries are dead, the display will not show
anything. You can still make or receive calls, but you can’t use
the Caller ID functions.
• If your batteries become completely drained, your caller ID data
and memories may be lost.
GETTING STARTED
Step 2: Telephone Installation
INSTALLING BATTERIES
5
CAUTION
Make sure that the telephone line cord is disconnected before
opening the battery door.
Replace the batteries when the LOW BATTERY INDICATOR
appears in the display or when the display gets dim.
Fig. 1 Fig. 2
Fig. 3 Fig. 4
IB-PH5435-WC-E-032805.pmd 4/1/2005, 12:28 PM 7