Linksys WAP51AB User Manual
Page 3
Wireless Network Access Point
Table of Contents
Chapter 1: Introduction
1
The Instant Wireless
TM
Dual-Band Wireless Access Point
1
Features
1
Package Contents
2
System Requirements
2
Chapter 2: Planning Your Wireless Network
3
Network Topology
3
Roaming
3
Chapter 3: Getting to Know the Dual-Band Wireless Access Point
4
The Dual-Band Wireless Access Point’s Back Panel
4
The Dual-Band Wireless Access Point’s Front Panel
5
Chapter 4: Connecting the Dual-Band Wireless Access Point
6
Chapter 5: Setting Up the Dual-Band Wireless Access Point
7
Chapter 6: Configuring the Dual-Band Wireless Access Point
16
The Setup Tab
16
The Password Tab
20
The Status Tab
21
The Help Tab
22
The Filter Tab
23
The Wireless Tab
24
Appendix A: Troubleshooting
27
Frequently Asked Questions
27
Appendix B: Setting Up the TCP/IP and IPX Protocols
32
Setting Up TCP/IP in Windows
32
TCP/IP Setup for Windows 95, 98, and Millennium
33
IPX Setup for Windows 95, 98, and Millennium
33
TCP/IP Setup for Windows NT 4.0
34
IPX Setup for Windows NT 4.0
34
TCP/IP Setup for Windows 2000
35
IPX Setup for Windows 2000
35
TCP/IP Setup for Windows XP
36
INDUSTRY CANADA (CANADA)
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
The use of this device in a system operating either partially or completely outdoors may require
the user to obtain a license for the system according to the Canadian regulations.
EC DECLARATION OF CONFORMITY (EUROPE)
Linksys Group declares that the Instant Wireless™ Series products included in the Instant
Wireless™ Series conform to the specifications listed below, following the provisions of the EMC
Directive 89/336/EEC and Low Voltage Directive 73/23/EEC:
ETS 300-826, 301 489-1 General EMC requirements for Radio equipment.
EN 609 50 Safety
ETS 300-328-2 Technical requirements for Radio equipment.
Note: This equipment is intended to be used in all EU and EFTA countries. Outdoor use may
be restricted to certain frequencies and/or may require a license for operation. For more
details, contact Linksys Corporate Compliance.
Note: Combinations of power levels and antennas resulting in a radiated power level of above
100 mW are considered as not compliant with the above mentioned directive and are not
allowed for use within the European community and countries that have adopted the European
R&TTE directive 1999/5/EC and/or the CEPT recommendation Rec 70.03. For more details on
legal combinations of power levels and antennas, contact Linksys Corporate Compliance.
Linksys Group™ vakuuttaa täten että Instant Wireless IEEE 802.11 PC Card tyyppinen laite on
direktiivin 1999/5/EY, direktiivin 89/336/EEC ja direktiivin 73/23/EEC oleellisten vaatimusten ja
sitä koskevien näiden direktiivien muiden ehtojen mukainen.
Linksys Group™ déclare que la carte PC Instant Wireless IEEE 802.11 est conforme aux con-
ditions essentielles et aux dispositions relatives à la directive 1999/5/EC, la directive
89/336/EEC, et à la directive 73/23/EEC.
Belgique B L’utilisation en extérieur est autorisé sur le canal 11 (2462 MHz), 12 (2467 MHz), et
13 (2472 MHz).
Dans le cas d’une utilisation privée, à l’extérieur d’un bâtiment, au-dessus d’un espace public,
aucun enregistrement n’est nécessaire pour une distance de moins de 300m. Pour une dis-
tance supérieure à 300m un enregistrement auprès de l’IBPT est requise. Pour une utilisation
publique à l’extérieur de bâtiments, une licence de l’IBPT est requise. Pour les enregistrements
et licences, veuillez contacter l’IBPT.
France F: Bande de fréquence restreinte: seuls les canaux 10, 11, 12, 13 (2457, 2462, 2467,
et 2472 MHz respectivement) doivent être utilisés en France.
Toute utilisation, qu'elle soit intérieure ou extérieure, est soumise à autorisation. Vous pouvez
contacter l'Autorité de Régulation des Télécommuniations
(
France F: Restricted frequency band: only channels 10, 11, 12, 13 (2457, 2462, 2467, and
2472 MHz respectively) may be used in France. License required for every indoor and outdoor
installations. Please contact ART for procedure to follow.
Deutschland D: Anmeldung im Outdoor-Bereich notwending, aber nicht genehmi-
gungspflichtig. Bitte mit Händler die Vorgehensweise abstimmen.
Germany D: License required for outdoor installations. Check with reseller for procedure to fol-
low
Italia I: E' necessaria la concessione ministeriale anche per l'uso interno. Verificare con i riven-
ditori la procedura da seguire. L'uso per installazione in esterni non e' permessa.
Italy I: License required for indoor use. Use with outdoor installations not allowed.
the Netherlands NL License required for outdoor installations. Check with reseller for proce-
dure to follow.
Nederlands NL Licentie verplicht voor gebruik met buitenantennes. Neem contact op met
verkoper voor juiste procedure