LevelOne FCS-1060 - Manual (Page 44)

44
Send out the snapshot while motion detection
There are three windows for motion detection each can be assigned a name. Select the windows
which need to be monitored. If motion detection has not been set up, “undefined” will be shown
instead of the window title. If this happens, clicking on “Motion detection” and a note will show to
direct the User to the configuration page for motion detection.
“Send pre-event image(s)” The number of pre-snapshots will be captured and send when a
condition is triggered.
“Send post-event image(s)”
The number of post-snapshots will be captured and send when a
condition is triggered.
“Delay second(s) before detecting next motion” Set the time delay before restarting to check
on the triggering condition when the current condition is triggered.
Sequential operation
“Snapshot interval (seconds)”
Network Camera will send snapshots at the specified intervals to
the external server using the method selected below. Remember: This operation is still subject to
the conditions set in the weekly schedule.
Method for sending snapshot
“Email”
This selects the uploading method following the intervals set above. The snapshot
named “prefix-yyyymmdd-hhmmss.jpg” will be attached in the email.
“FTP” The snapshots will be uploaded to the external FTP server with the file name defined in the
next option. This can also be used to refresh the captured images stored in the external web
server to build creative homepages.
“FTP put snapshots with date and time suffix” This option sets up the snapshot capture date
and time, which can be used to easily differentiate the snapshot file names in the sequential
operation. For instance, “prefix-20030102-030405.jpg” means the JPEG image was captured in
the year 2003, January the 2
nd , at 3 o’clock, 4 minute, and 5 second. If this suffix is omitted, the file
named “video.jpg” on the external FTP server will be refreshed at the specified interval.