Little Wonder Line Trimmer - Manual (Page 8)

7
Replacement spools can be ordered through your Mantis dealer.
1. For safety reasons, do not use metal reinforced line.
2. For replacement use 0.095" dia line. The spool is capable to
hold approximately 20' long line.
3. Hold spool holder and remove spool by turning it clockwise
until it stops. Do not press the spool down when turning!
Pull the spool and remove old line.
4. Put each end of the new line through the holes in the spool
and pull it until one end is approx. 6" longer then the other.
(Pictures 14 and 15)
5. Hold the spool, so the opening is facing you, and wind up
the line tightly and evenly in the clockwise direction,
separating both line halves by finger as shown below.
(Pictures 16 and 17)
6. Insert line into the slots in the spool, and leave approx 6-8”
in of line unwind, then put the ends through the eyelets on
the spool holder. (Pictures 18 and 19)
7. Align bosses of the drive with the grooves in the spool, and
push it in place.
8. Pull both lines until they come free from the slots in the
spool.
9. Hold drum and turn spool counter clockwise until it stops.
Do not press the spool down when turning! (Picture 20)
Refilling the Trimming Line
Picture 14 Picture 15
Picture 16 Picture 17
Picture 19 Picture 18
Eyelets
WARNING DANGER
NEVER REPLACE OR ADJUST THE TRIMMING
LINE WHILE MOTOR IS RUNNING!
DISCONNECT POWER CORD FROM
THE POWER SOURCE.
Picture 20
Holes Approx. 6" longer