Lenoxx Electronics CD203 - Manual (Page 9)

IB-CD203(AD)-WM-E-012503
PLAYING CD TRACKS IN PROGRAMMED OR
RANDOM ORDER
To change the current program
Just create a new program following the programming procedure.
To cancel Programmed Play
Press the STOP button, then rotate the FUNCTION switch to TAPE position.
2. Random Play
To play the songs in random order
Press the RANDOM button, and the display will show some moving symbols
like “
...
...
” every 5 second.
Press to skip to next random song.
8
1. Programmed Play
You can make a program of up to 16
tracks in the order you want them to be
played.
PROGRAM
NOTE:
1. Programming can only be done in STOP mode.
2. The programmed memory will be lost if the STOP button is pressed, or the AC
plug is shut off, or the CD door is opened.
1. Rotate the FUNCTION switch to CD position.
Make sure the CD is stopped.
2. Press the PROGRAM button. The letters “P0” will
show and the PLAY/PROG. lamp will flash.
3. Press or to select the tracks you want to
program in the order you want.
4. Press the PROGRAM button to confirm. The letters
“P1” will show and the PLAY/PROG. lamp will flash.
5. Repeat above steps 3 and 4. You can program up
to 16 tracks (the display will show “Pa”, “Pb” ...
“Pf” for program#11-16).
6. Press to start programmed play. The PLAY/
PROG. lamp will flash.
To resume normal play
Press the RANDOM button again, the player will start play normally.
REPEAT
PLAY/
PROG.
REPEAT
PLAY/
PROG.
PLAY/PAUSE FORWARD
BACKWARD RANDOM