Wwarning – LG TROMM WM2455H User Manual

Page 18

O P T I O N A L AC C E S S O R I E S

PEDESTAL ACCESSORY

The pedestal accessory includes:
• Pedestal base

• Eight (8) screws

• One (1) drawer divider

• Wrench

• Four (4) brackets

WARNING

•

Incorrect installation can cause serious

accidents.

•

The appliances are heavy. Two or more

people are required when installing the

pedestal. There is a risk of serious back injury

or other injuries.

•

Do not allow children to play in or on the

drawer. There is a risk of suffocation or injury.

•

Do not step on the handle. There is a risk of

serious injury.

•

If appliances are already installed,

disconnect them from all power, water, or

gas lines and from draining or venting

connections. Failure to do so can result in

electrical shock, fire, explosion, or death.

To ensure safe and secure installation, please

thoroughly follow the instructions below.

PEDESTAL INSTALLATION

Tools Needed for Installation:

• Phillips-head screwdriver
• Wrench (supplied)

Make sure the leveling feet of the appliance
are fully retracted (see detail for leveling
washer feet in Step 2); then position the
appliance on top of the pedestal.
The washer feet will fit into the outermost
corner positions and the dryer feet will fit into
the innermost positions as shown.
NOTE: The appliance and pedestal assembly

must be placed on a solid, sturdy, level floor
for proper operation.

Once the leveling feet of the

washer are fully

retracted, tighten all locknuts securely.
NOTE: The leveling feet on the dryer do not

have locknuts.

Tighten all 4

locknuts securely

For washer/combo

For dryer

PEDESTAL INSTALLATION

(cont.)

Install 2 screws to securely attach the bracket

to the pedestal.

Once properly attached, firmly press the top

part of the bracket with the double-sided

tape to the side of the appliance. Repeat

steps 2–4 to attach the other brackets.

NOTE: If the brackets are not installed

properly, noise and vibration may result. Be

sure to remove paper backing and to use all

screws to install the brackets.

Move the appliance to the desired location.

Make sure the side surface of the appliance

is clean and dry. Remove paper backing from

the tape on the bracket.

Position the bracket as shown. The bent part

of the bracket should rest along the edge

of the pedestal, and the holes in the bottom

part of the bracket should align with the

holes in the pedestal.

Loosen the locknuts on all 4 leveling feet

of the

pedestal until you can turn them

with the wrench. Turn clockwise to raise

or counterclockwise to lower. Once the

pedestal is level and all 4 feet are solidly

against the floor, securely tighten all locknuts

by hand.
NOTE: Noise and vibration may result if

locknuts are not tightened.

Be sure to connect the appliances to all

water, power, or gas lines and draining or

venting connections before operation.

If there is excessive vibration during the

first operation after installation, slightly

adjust the leveling feet.

Raise

Lower

MFL31245113_ENG.indd 34-35

2007.10.4 2:32:11 PM