Lenovo C92 - Manual (Page 7)

E-7
SERVICING
Refer all servicing to qualified service personnel.
Serious shock hazards exist within the covers of
this monitor.
Do not open the covers under any circumstances -
there are no serviceable parts inside.
1 5
15
*Note: This pin is used for self test detection; at
PC side, this pin has to be connected to
ground.
n i P n o i t c n u F n i P n o i t c n u F
1 l a n g i s d e R 9 C N
2 l a n g i s n e e r G 0 1 d n u o r g l a t i g i D
3 l a n g i s e u l B 1 1 d n u o r G
4 d n u o r G 2 1 ) B 2 C D D / 1 C D D ( A D S
5 * 3 1
l a t n o z i r o H
n o i t a z i n o r h c n y S
6 n r u t e r d e R 4 1
n o i t a z i n o r h c n y s l a c i t r e V
) 1 C D D ( K L C V &
7
n e e r G
n r u t e r
5 1 ) B 2 C D D ( L C S
8 n r u t e r e u l B
SIGNAL CONNECTOR
INFORMATION
* Note: You can easily distinguish the problem is on
the monitor or on the computer by using the
monitor’s built-in selftest function.
With the monitor power ON, disconnect the
signal cable from monitor. If you see a “NO
SIGNAL” image on the screen, (shown
below) the monitor is function properly, and
the problem is at PC side, or signal cable.
NO SIGNAL