Life Fitness X9i User Manual

Page 6

Step 4
Detach and unwrap the WIRE HARNESS (E) (10P, 3P, 4P) located at
the top of the MONOCOLMN (F). Holding the CONSOLE SUPPORT
ASSEMBLY (#7) with the handgrips facing upward, feed the WIRE
HARNESS up through the neck and out the top access hole. Carefully
lower the CONSOLE SUPPORT ASSEMBLY into the
MONOCOLUMN.

CAUTION: BE CAREFUL NOT TO PINCH THE WIRE HAR-
NESSES (E) WHEN ASSEMBLING THE CONSOLE SUP-
PORT ASSEMBLY (#7) TO THE MONOCOLUMN (F)

MISE EN GARDE : VEILLEZ À NE PAS PINCER LE FAIS-
CEAU DE CÂBLES (E) LORS DU MONTAGE DU SUPPORT
DE LA CONSOLE (Nº 7) SUR LA COLONNE CENTRALE (F).

Step 5
Using two HEX SOCKET HEAD CAP SCREWS (#1) and two FLAT
WASHERS (#8), secure the CONSOLE SUPPORT ASSEMBLY (#7) to
the MONOCOLUMN (F). Tighten the screws securely.

Step 6
Locate the ACCESSORY TRAY (#17). Align the ACCESSORY TRAY
with the bottom of the DISPLAY CONSOLE (#4) as shown. Using four
MOUNTING SCREWS (#2), secure the ACCESSORY TRAY to the
DISPLAY CONSOLE as shown. Tighten the screws securely.

CAUTION: DO NOT OVER-TIGHTEN THE PHILLIPS HEAD
PAN SCREWS (#2).

MISE EN GARDE : NE SERREZ PAS TROP LES VIS CRUCI-
FORMES À TÊTE CYLINDRIQUE (Nº 2).

Step 7
Attach the 3-PIN (3P), 4-PIN (4P) and 10-PIN (10P) CONNECTORS to the
corresponding jacks on the back of the CONSOLE ASSEMBLY (#4).

Step 8
Feed any excess WIRE HARNESS (E) down into the CONSOLE SUPPORT ASSEMBLY (#7). Secure the
CONSOLE ASSEMBLY (#4) to the CONSOLE SUPPORT ASSEMBLY using four PHILLIPS PAN HEAD SCREWS
(#2). Tighten the screws securely.

CAUTION: DO NOT OVER-TIGHTEN THE PHILLIPS HEAD PAN SCREWS (#2).

CAUTION: BE CAREFUL NOT TO PINCH THE WIRE HARNESS (E) WHEN ASSEMBLING THE CON-
SOLE ASSEMBLY (#4) TO THE CONSOLE SUPPORT ASSEMBLY (#7).

MISE EN GARDE : NE SERREZ PAS TROP LES VIS CRUCIFORMES À TÊTE CYLINDRIQUE (Nº 2).

MISE EN GARDE : VEILLEZ À NE PAS PINCER LE FAISCEAU DE CÂBLES (E) LORS DU MONTAGE
DE LA CONSOLE (Nº 4) SUR SON SUPPORT (Nº 7).

Step 9
Locate and install the CONSOLE SUPPORT CAP (#21) onto the CONSOLE SUPPORT ASSEMBLY (#7) as
shown.

10P