How to...replace or install rear roller guards – Life Fitness 95Ti User Manual
Page 2
M051-00K58-B128
Life Fitness Model 97Ti, 95Ti, 93T Treadmills
How To...Replace or Install Rear Roller Guards
Tools Required: Philips Screwdriver, Flat Blade Screwdriver
5. Carefully remove the LOW PROFILE SQUARE
GROMMET from the bottom of the BASE FRAME.
(Configuration 1 Only)
CAUTION: Be careful not damage the LOW
PROFILE SQUARE GROMMET when removing it
from the BASE FRAME.
6. Reinstall the LOW PROFILE SQUARE GROMMET
back in the upper hole in the BASE FRAME.
(Configuration 1 Only)
7. Position the new ROLLER GUARD, which has a
larger, wider surface, under the STRIDING BELT.
Align the mounting holes and install the ROLLER
GUARD MOUNTING SCREWS.
8. Repeat STEPS 2 through 7 for the remaining
ROLLER GUARD. Upon completion, run the
treadmill and check for interference or binding. If
necessary realign the ROLLER GUARDS. Tighten
the MOUNTING SCREWS to 22-37 in lbs.
NOTE: After installation,
make sure the Roller
Guard
in contact
with the Frame in this area.
IS NOT