Linn UNIDISK 2.1 PLAYER - Manual (Page 14)

General Setup
OSD Language (on-screen display
language)
Default setting: E En ng glliis sh h
Choose the language you want on-screen information
and menus displayed in.
Aspect Ratio
Default setting: 116 6::9 9
Choose the option that matches your display device;
either 4
4::3 3, L Le etttte errb bo ox x or 116 6::9 9.
Video Standard
Default setting: N Na attiiv ve e
Choose the option that matches the video signal
standard accepted by your display device. Set to N
Na attiiv ve e
if your display device accepts both NTSC and PAL
standards.
Notes:
If TV Type is set to N
Na attiiv ve e you may notice the screen flicker when a DVD-Video begins to
play. This happens when the UNIDISK 2.1 switches from one video signal standard to the
other.
If your display device only accepts one type of standard, you may not be able to view
DVD-Videos on the UNIDISK 2.1 that have been recorded in the other standard.
NTSC Type
For countries that use the NTSC signal standard.
Default setting: N
No orrtth h A Am me erriic ca an n
If in the U.S.A. or Canada, set to N No orrtth h A Am me erriic ca an n.
If not in the U.S.A. or Canada, set to W Wo orrlld d.
Prim. (Primary) Display Device
Default setting: IIn ntte errlla ac ce ed d
The UNIDISK 2.1 is able to account for the video delay
inherent in the processing required for progressive
video signals, thus ensuring both video and audio
signals are output simultaneously. Set this option to
suit the main display device in your AV system.
Note:
If you wish to use the UNIDISK 2.1’s HDCP output, your display device must be HDCP
compatible. No picture will be available on a display device that has a DVI input but is
not HDCP compatible.
Interlaced Out
Default setting: Y YP PrrP Pb b
If your display device accepts an RGB input then you
must use the SCART output on the UNIDISK 2.1 and
Interlaced Out must be set to R
RG GB B. In this situation
there is no YPrPb output.
If your display device accepts a YPrPb input then you
can use either the SCART or YPrPb outputs on the
UNIDISK 2.1. In this case, set to Y
YP PrrP Pb b.
Colour Level
This option is only for use if the YPrPb interlaced
outputs on the UNIDISK 2.1 are used.
Default setting: A
Au utto o
The Colour Level option adjusts the amount of colour
information sent to your display device.
If you want the UNIDISK 2.1 to determine the setting
based on the video format of the disc being played, set
to A
Au utto o.
If your display device accepts a 1V peak-to-peak input, set to H Hiig gh h.
If your display device accepts a 0.7V peak-to-peak input, set to L Lo ow w.
English
UNIDISK 2.1 PLAYER
Owner's Manual 9
Setup Menus