Braun 4875 SmartControl3 - Manual (Page 5)

5
• Next, switch off the shaver and press
the release buttons. Remove the shaver
foil and the cutter block. Then leave the
disassembled shaving parts to dry.
• If you regularly clean the shaver under
water, then once a week apply a drop of
light machine oil onto the long hair trimmer
and shaver foil.
Alternatively, you may clean the shaver using
the brush provided:
• Switch off the shaver. Remove the shaver
foil.
• Using the brush, clean the cutter block and
the inner area of the shaver head. However,
do not clean the shaver foil with the brush
as this may damage the foil.
Keeping your shaver in top
shape
About every four weeks, clean the cutter block
with Braun cleaning agents.
Preserving the batteries
In order to maintain the optimum capacity
of the rechargeable batteries, the shaver
has to be fully discharged (by shaving) every
6 months approximately. Then recharge the
shaver to full capacity. Do not expose the
shaver to temperatures higher than 50 °C for
extended periods of time.
Replacing the shaving parts
To maintain 100% shaving performance
replace your foil and cutter block at least every
18 months or when worn. Change both parts
at the same time for a closer shave with less
skin irritation.
(Shaver foil and cutter block: 4000 series)
Environmental notice
This product contains rechargeable
batteries. In the interest of protecting
the environment, please do not dispose
of the product in the household waste
at the end of its useful life. Disposal can
take place at a Braun Service Centre or at
appropriate collection points provided in
your country.
Subject to change without notice.
This product conforms to the European
Directives EMC 89/336/EEC and Low
Voltage 73/23/EEC.
For electric specifications, see printing on the
special cord set.
FIX400_4875_AMEE Seite 5 Montag, 10. April 2006 8:17 08