Braun 2876 - Manual (Page 6)

7
Activate the on/off switch (6). The floating foil frame
automatically adapts to your skin surface for a close,
smooth shave.
For pre-shaving after a few days of not having shaved, use
the wide shaper (4a) to pre-cut long hairs. For a close,
smooth shave, finish with the foil.
Using the styler
• The wide shaper (4a) evenly cuts and trims larger areas
(c): Ideal for shaping sideburns, moustaches and partial
short beards. Press the blue rib to push out the styler (4).
• The narrow shaper (4b) precisely defines lines and
edges (d): Ideal for precise contouring. To use the
narrow shaper, push out the styler and turn it 180°.
• Frequent use of the styler may reduce the battery
capacity.
Using the trimming attachment
• The trimming attachment (7) is ideal for beard trimming
and keeping it at a constant length.
• Place the trimming attachment onto the shaver foil (2)
and press it against the shaver housing until it snaps into
place with a click.
• Press the beard length selector (8) (e) and slide it up in
order to set the desired beard length (length settings
from top to bottom 1.2 mm, 2.8 mm, 4.4 mm, 6 mm).
Push out the styler (4).
• Activate the on/off switch and trim against hair growth
by guiding the transparent comb part over the skin.
• After use, pull back the styler. Remove the trimming
attachment (a).
Cleaning
This appliance is suitable for cleaning under an open
water tap.
Warning: Detach the hand-held part from the power
supply before cleaning it in water.
Regular cleaning ensures better shaving performance.
Rinsing the shaving head after each shave under running
water is an easy and fast way to keep it clean:
•
Switch the shaver on (cordless) and rinse the shaving
head under hot running water (f). A natural based soap
may also be used provided it contains no particles or
Tips for the perfect shave
• We recommend that you shave before washing, as
the skin tends to be slightly swollen after washing.
• Hold the shaver at right angles (90°) to the skin (b).
Stretch the skin and shave against the direction of
beard growth.
• To maintain 100% shaving performance, replace your
foil and cutter block at least every 18 months or when
worn.
5733331_Cruzer_2876 Seite 7 Mittwoch, 5. April 2006 9:28 09