LG LW1000ER - Manual (Page 19)

19
ENGLISH
Sash track
Front Angle
About
1
/ 2
"
Screw(Type B) 6
Screw(Type B) 6
Sill Support 2
Sill Support 2
Foam-Strip 8
Fig. 5
Type C 7
Fig. 6
Screw(Type A)
Screw
(Type A)
Power cord
Fig. 7
Fig. 8
The cabinet should be installed with a very slight tilt
(about 1/2") downward toward the outside
(See Fig. 5).
Adjust the bolt and the nut of Sill Support
for
balancing the cabinet.
Attach the cabinet to the window stool by driving
the screws
(Type B: Length 16mm (5/8 inch)
and below.) through the front angle into window
stool.
Pull each Frame Curtain fully to each window
sash track, and repeat step 2.
Attach each Frame Curtain the window sash using
screws (Type C). (See Fig. 6)
Slide the unit into the cabinet. (See Fig. 7)
Cut the Foam-Strip to the proper length and insert
between the upper window sash and the lower
window sash. (See Fig. 8)
11
10
9
8
7
6
CAUTION: Do not drill a hole in the bottom
pan. The unit is designed to operate with
approximately 1/2" of water in bottom pan.
There is no need to add water if the pan is
dry.
CAUTION: For security purpose, reinstall
screws (Type A) at cabinet's sides.