Loewe 46 - Manual (Page 36)

- 6
Explanations of important settings
The signal type of the devices that can be connected can
vary greatly. If you are not sure, leave the setting for Signal
on Automamtic CVBS/YC (e.g. for DVD Player/Recorder) or
Autom.-VHS/SVHS (e.g. video recorder), otherwise select
the right signal type. See the glossary on page 56 for
further information.
If the picture from a connected device is to be displayed
immediately on the TV set during playback, select yes. A
switching voltage is allowed so that you do not have to
switch over manually to see the picture of the connected
device. (See the operating manual of the connected re-
production device.)
When playing from Digital Link Plus devices, the picture is
always displayed immediately, regardless of the setting.
Select the AV socket to which the device of which you
want to hear the digital sound is connected. Connect the
digital output of the external device to the digital input
of the TV set (see page 45). If a device with digital audio
is not connected then select
no.
Connection possibilities for a DVD/video recorder
There are two possibilities for viewing the picture of the connected
recorder:
1. Use appropriate cables in conjunction with the connections assigned
by the connection wizard. This always offers the best quality and
the greatest convenience, such as automatic switch over when
playing from a connected device.
2. You are using the antenna connection between recorder and TV
device. However this reduces the quality.
Connecting antenna to the DVD/video recorder
If you want to receive and record analogue stations, it is useful to loop
the recorder into the antenna cable; as shown in the connection example
on page 5 bottom right.
If the antenna connection is also used for the playback because the
devicers are not connected by EURO-AV cables, you have to search for
the recorder station and save it in the TV set.
Proceed as follows (see also the operating manual of the connected
recorder):
➠ Insert a DVD/cassette and press play.
Call AV selection.
34 Select VIDEO,
OK to switch over.
If no picture is visible on the TV screen during recorder
playback, you have to search for the station or set it
manually.
To avoid finding "normal" television stations when search-
ing for stations, unplug the antenna plug on the record-
er's antenna input temporarily (the cable for the antenna
system).
Manual station search:
➠ VIDEO is selected by the AV selection.
Call TV menu.
34 Select Settings,
6 go to the menu line below.
34 Select Stations,
6 go to the menu line below.
34 Select Manual adjustment,
OK to call other settings.
For Channel enter "E30".
Blue button: Start search.
When you have found the recorder station:
Red button: Overwrite station slot.
Exit TV menu.
Re-connect the antenna plug that you temporarily
unplugged.
If disturbances should now occur because a TV station
is being broadcast on the same channel as the station
of the recorder, then you must change the transmission
channel on the recorder and scan for the recorder again
on the TV set.
Operating additional equipment
Signal type
Immediate
playback
Assign digital
audio input