LG GSA-4120B - Manual (Page 9)

6
To Install as a Slave Drive
To install the drive as a Slave, change the jumper setting on the rear panel to SL.
Connecting the Power Connector
Connect the power cable from the computer’s power supply to the socket on the drive unit,
fitting the connector firmly into the power in connector. If there is no spare power cable
available in the computer, you will have to purchase a splitter cable of a suitable type.
Connecting the Interface Connector
Connect the 40-pin IDE cable to the back of the Super Multi DVD Drive, making sure the
coloured (red) stripe on the IDE cable is connected to pin 1 on the Super Multi DVD drive
(Pin 1 is closest to the Power Connector).
Slave drive
(Super Multi
DVD Drive)
(Jumper set to
Slave)
Master drive
(Booting hard disk)
- OR -
DIGITAL ANALOG INTERFACE POWER D R C S M
S L A G L G 39 1 +5 +12 GND 40 2
AUDIO AUDIO
Primary
connector
Secondary
connector
Master drive
(Other IDE drive)
Slave drive
(Super Multi
DVD Drive)
(Jumper set
to Slave)
DIGITAL ANALOG INTERFACE POWER D R C S M
S L A G L G 39 1 +5 +12 GND 40 2
AUDIO AUDIO
DIGITAL ANALOG INTERFACE POWER D R C S M
S L A G L G 39 1 +5 +12 GND 40 2
AUDIO AUDIO
Master drive
(Booting hard disk)
AUDIO OUT SELECT IDE INT ERFAC E CON NECTO R
INPUT DC
39
40
1
2 5V GN D 12V
R GND L C.SEL SLAVE MASTER
5V GND 12V
CD INPUT
Beveled edge up
NOTE : Improper connection may damage
the drive and void the warranty. Generally,
the power connector can only fit one way.
AUDIO O UT SELECT IDE INT ERFAC E CON NECTO R
INPUT DC
39
40
1
2 5V GN D 12V
R GND L C.SEL SLAVE MASTE R
Pin1
Red-edge
NOTE : Generally, the IDE connector is
keyed and will only fit one way.