Lenoxx Electronics CD-91 User Manual

Page 16

TROUBLE SHOOTING GUIDE

S Y M P T O M S

C A U S E S

S O L U T I O N S

Tracks do not

change or set does

not play normally.

Batteries are too weak (they

may test OK on tester, but

they are weak).

Replace both batteries with fresh alkaline batteries.

Battery life with fresh batteries is about 8 hours

(rechargeable batteries have 1/2 of that life).

CD Player will not

turn on.

Dead or weak batteries.
AC Adaptor not connected

properly.

Replace both batteries with fresh ones.

Check AC Adaptor connections at the AC outlet

and the rear of set.

Disc will not play.

Disc inserted incorrectly.

Defective compact disc.

CD Door not closed.

Moisture has formed inside

the CD deck.

Re-insert disc with label side facing up.

Try another compact disc (scratched and dirty

discs will not play).

Close the Door (lid) securely.

Take out the CD and leave the CD Door open for

about an hour to dry the moisture condensation.

No sound from

headphones.

Headphone plug not inserted

properly.

Check the following guide before calling customer service.

Bass Boost Switch is ON.

ON.

Press Bass Boost Switch to OFF.

Weak batteries.

Music is too loud.

Sound is distorted.....

Buttons do not

work.

Electronic or static error

caused circuitry to lock.

Remove batteries and Adaptors. Wait a few

seconds and re-insert. Make sure batteries are

fresh or Adaptor has power.

Replace both batteries or use AC Adaptor.

Lower Volume Control.

Volume Control set to

minimum.

Weak batteries.

Defective compact disc.

Re-insert headphone plug into Phones

Phones

Phones Jack

(not Aux Out).
Increase the volume.

Replace with fresh batteries or use AC Adaptor.
Try another compact disc.

Volume Control

has no function

Headphones plugged into

Aux Out Jack.

Plug headphones into Phones Jack .

(NOT THE AUX OUT JACK)

Sound is skipping

or sound stops.

The compact disc or lens is

dirty or CD is scratched.

Strong vibrations.
Anti-skip is off.

Clean or replace the compact disc or clean the

lens.
Place the CD player on a level surface that is

stable or press ESP Button.
Turn on ESP function.