Life Fitness Lat Pulldown - Manual (Page 5)

8. Assemble the OUTPUT CAM (20), OUTPUT PLATE (21), and OUTPUT
RING (22) using three M10 X 45mm BOLTS (23) and three 3/8" SAE
WASHERS (5) as shown. Tighten the BOLTS securely.
9. Assemble the REAR SHROUD (24) and FRONT SHROUD (25) to the
TOWER (3) using four M10 X 20mm BOLTS (26), four 3/8" SAE WASH-
ERS (5) as shown. Be sure all tabs along the sides and top of the
SHROUDS are fully engaged in the slots located inside the TOWER.
Tighten the BOLTS securely. Do not overtighten the BOLTS.
10. Secure the OUTPUT CAM ASSEMBLY (B) to the TOWER HUB (C) using
one M10 X 25mm BOLTS (19), one 3/8" SAE WASHERS (5) and one
PLATE (27) as shown. Tighten the BOLT securely.
IMPORTANT: Be sure the OUTPUT CAM ASSEMBLY is oriented as
shown before securing it to the TOWER HUB.
11. Attach the CAM GUARD (28) to the FRONT SHROUD (25) using two M5
X 10mm PHILLIPS SCREWS (29). Tighten the SCREWS securely. Do not
overtighten the SCREWS.