Kompernass PWS 1200 - Manual (Page 12)

14 GB/IE/CY
Cup brush, twisted wire
Dimensions:
ø 75 mm
Cup brush, knotted wire
Dimensions:
ø 115 mm
Adjusting the disc guard cover
J Pull the mains plug out of the mains socket
before you carry out any task on the device.
J Danger of injury! Always use the angle
grinder with the disc guard cover
6 in place.
The disc guard cover must be securely attached
to the angle grinder. To ensure the highest level
of safety while using the device,
ensure that the smallest possible area of the
grinding or cutting tool is exposed to the opera-
tor at all times. The disc guard cover
6 is there
to protect the operator from pieces breaking off
and accidental contact with the grinding or cut-
ting tool.
The disc guard cover has 5 set positions.
j Turn the disc guard cover 6 into the desired
position (working position). The closed side of
the disc guard cover
6 must always be facing
the operator.
Using the auxiliary handle
m Attention! For safety reasons this device must
always be used with the auxiliary handle 5 in
place. The auxiliary handle 5 can be screwed on
to the left, right or on the top of the head of the
device.
Maintenance and cleaning
J Pull the mains plug out of the mains socket
before you carry out any task on the device.
J Do not use sharp objects for cleaning the
device. Do not allow any liquids to enter the
device.
j Have the carbon brushes replaced only at the
service centre or an accredited electrical equip-
ment repair centre. The device requires no oth-
er maintenance.
j Clean the device frequently; for best results do
this immediately after you have finished using it.
j Use a dry cloth to clean the housing – under
no circumstances use petrol, solvents or clean-
ing agents that attack plastic.
j A vacuum cleaner is required to thoroughly
clean the device.
j Ventilation openings must always be kept free.
j Remove any adhering dust with a narrow paint
brush.
Disposal
The packaging is wholly composed of en-
vironmentally-friendly materials that can be
disposed of at a local recycling centre.
Do not dispose of electrical
power tools with the household
rubbish!
In accordance with European Directive
2002 / 96 / EC (covering waste electrical and elec-
tronic equipment) and its transposition into national
legislation, worn out electrical power tools must be
collected separately and taken for environmentally
Use of accessories / Maintenance and cleaning / Disposal