Kambrook KSK210 - Manual (Page 8)

7
Operating Your Kambrook Kettle
Before First Use
Remove any packaging material and
promotional labels before using your
kettle for the first time.
It is recommended that before the first
use to fill the kettle to the maximum
level with cold tap water, bring to
the boil and then discard the water.
Your kettle will only operate when
positioned on the power base with
the ON/OFF switch in the ON position.
The kettle will automatically switch off
once the water has boiled.
To Use the Kettle
1. To fill the kettle with water,
remove it from the power base
and open the lid by pressing
the button located on the top
of the handle and the lid will lift
upwards. Fill with the desired
amount of water. Do not operate
the kettle without water. Always
fill the kettle between the “MIN”
and the “MAX” marks on the
water window. Too little water will
result in the kettle switching off.
2. Ensure that the lid is closed
and locked firmly into place
before placing the kettle on
the power base.
3. Place the kettle firmly onto the
power base. Plug the power cord
into a 230V or 240V power outlet
and switch ‘ON’.
4. Press the ON/OFF switch to the
‘ON’ position. The power ‘ON’
light will illuminate.
NOTE: Never operate the kettle
dry - too little water will result in
the kettle switching “OFF”.
Do not overfill the kettle - filling
above the maximum mark on
the water window may result
in boiling water splashing from
the kettle.
NOTE: This kettle must only
be used with the power base
supplied. Use caution when
pouring water from your kettle,
as boiling water will scald. Do
not pour the water too quickly.
NOTE: Do not remove the kettle
from the power base during
operation. Ensure the kettle has
switched to the “OFF” position
after the water has boiled
before removing the kettle from
the power base.
5. The kettle will automatically switch
‘OFF’ once the water has boiled.
Lift the kettle from the power base
and pour the water. Take care to
hold the kettle level, especially
when filled to the maximum level.
To re-boil it may be necessary to
wait for a few seconds to allow
the control to reset.