Kawasaki 840194 - Manual (Page 6)

CHARGING BATTERY PACK
CHARGE BATTERY PACK:
1. Make sure the trigger on
the Cordless Impact
Wrench is in the “OFF”
position and remove the
battery pack from the
Impact Wrench.
2. Insert the battery pack into the
charger. Be sure that the battery
pack is fully seated in the charg-
er. Do not force.
3. Plug the charger into the nearest
120 volt, electrical outlet. The
indicator light will come “ON”.
INDICATOR LIGHTS OF CHARGER
RED
Power On The Charger is power on.
Battery -
Faulty The battery life may end or the battery
voltage may be in extraordinary
conditions. Please unplug the charger,
then replace the battery pack.
YELLOW
Battery in High
Temperature The battery pack is overheated. Please
wait until the battery pack cools
down, or take it out from the charger
temporarily to be cooled off.
Battery in Low
Temperature The battery pack’s temperature is too
low. Please wait untl the battery pack’s
temperature rises to 50°F.
Incorrect
Battery Type The battery pack is unspecified or has
failed. Please replace the battery pack
with a new one.
GREEN
Fast Charging The battery is under Quick Charging.
Fully Charged The charging is completed. Please
take the battery pack out from the
charger, then unplug the charger
from the power supply outlet.
10
REMOVING / ATTACHING BATTERY PACK
REMOVE BATTERY PACK:
1. Press both release buttons on either side
of the Impact Wrench to release the bat-
tery pack.
2. Pull battery pack free of Impact Wrench.
ATTACH BATTERY PACK:
1. Align the raised portion of the battery pack
with the groove in the battery compart-
ment of the Impact Wrench.
2. Press the battery pack into place. Make
sure the latches are securely fastened. Do
not use the Impact Wrench if the battery
pack is not
seated properly.
CHARGER
Before using battery charger, please read carefully all
instructions and cautionary markings on battery charger, battery pack and
product using battery.
The charger will not automatically turn “OFF” when the
battery pack is fully charged. The charging indicator light will remain “ON”
until the charger is disconnected from the electrical outlet.
Use only the charger which accompanied your product or direct replacement as
listed in this manual. Do not substitute any other charger. Use only Alltrade
approved chargers with your product.
Do not disassemble charger.
Do not use charger if it has been damaged, left outdoors in the rain, snow, wet
or damp environments, or immersed in liquid.
The battery pack and charger heat during charging. Place the charger on a flat,
non-flammable surface away from flammable materials with at least four inches of
clearance to allow proper air circulation around the charger and battery pack.
When the battery pack requires recharging, a 1 hour charge allows the tool to
operate at full power. A charging indicator light on the charger will illuminate to
show that charging is taking place.
9
RELEASE
BUTTON
BATTERY PACK
BATTERY
CHARGER