Kenwood FleetSync TK-8102H - Manual (Page 12)

8
DTMF CALLS
Note: To make DTMF calls, you must have an optional microphone with a DTMF keypad.
M
ANUAL
D
IALLING
Press and hold the PTT switch, then enter the digits on the microphone keypad.
• You can enter the digits 0 ~ 9, A ~ D, , and #. (A ~ D may be disabled by your dealer.)
• If programmed by your dealer, you do not need to continuously hold the PTT switch;
the transceiver will remain in the transmit state for 2 seconds after releasing each key.
• While transmitting DTMF tones, the microphone is muted.
S
TORING
DTMF N
UMBERS
If Auto Dialling has been activated by your dealer, you can store DTMF numbers
(16 digits maximum) in each of the 9 Auto Dial memory locations (1 ~ 9).
1 Press the microphone # key.
2 Enter the desired digits on the microphone keypad.
• You can enter the digits 0 ~ 9, A ~ D, , and #.
• When entering “#”, you must first press the PTT switch.
• To cancel, press any key on the transceiver front panel, other than the switch.
3 Press the microphone # key, then enter a memory location number (1 ~ 9).
• If no key is pressed within 10 seconds, the transceiver will return to normal operation.
D
IALLING
S
TORED
DTMF N
UMBERS
1 Press the microphone key.
2 Enter the desired memory location number (1 ~ 9).
3 Press the PTT switch.
• If programmed by your dealer, no DTMF tone will sound when “D” is transmitted.
“D” is used for a pause time. The pause duration is programmed by your dealer.
C
LEARING
S
TORED
DTMF N
UMBERS
1 Press the microphone # key twice.
• To cancel the process, press any key other than 1 ~ 9.
2 Enter the desired memory location number (1 ~ 9).
R
EDIALLING
1 Press the microphone key, then press the 0 key.
2 Press the PTT switch.
Note: Switching the transceiver power OFF clears the redial memory.