12 3 rear panel – Kustom GROOVE 410H User Manual

Page 3

Horn Attenuator:

Speaker Input/Output

This is a “volume” control for the

horn. To disable the horn, turn the
knob counter clockwise until the
indicator reaches

. To set the horn

for maximum output, turn the knob
clockwise until the indicator reaches .

These jacks can be used as an input

and/or output. The jacks accept a
standard

” cable.

When using

these jacks as an output to another
cabinet, refer to the Amplifier Loading
Chart (page 4) for important amplifier
loading information.

These jacks can be used as an input

and/or output. They accept standard
Speakon type speaker cables. To
connect a cable: Insert and twist one
quarter turn clockwise until the release
button locks. To remove a cable: Pull
back release button on cable connector,
twist connector counter clockwise one
quarter turn, and pull out connector.

When using these jacks as an

output to another cabinet, refer to the
Amplifier Loading Chart (page 4) for
important amplifier loading information.

Note:

HORN ATTENUATION dB

MADE IN CHINA

+1 tip, -1 sleeve

+1 and -1 used

INPUT/OUTPUT

MODEL: GROOVE 410H

XXXX-XXXXXX

IMPEDANCE: 8 OHMS
POWER:

500 WATTS RMS

SENSITIVITY:95dB 1W/1M

Rear Panel