Karcher K205 M Plus - Manual (Page 4)

3
Water Supply
(Cold Water Only)
• Water hose must be at least 3/4 inch
in diameter.
• Flow rate of water supply must not fall
below 2.5 GPM (gallons per minute).
• Flow rate can be determined by running
the water for one minute into an empty
5-gallon container.
IMPORTANT PRECAUTIONS – continued
• The water supply temperature must not
exceed 104°F/40°C.
• Never use the pressure washer to draw in
water contaminated with solvents, e.g. paint
thinners, gasoline, oil, etc.
• Always prevent debris from being drawn into
the unit by using a clean water source.
ASSEMBLY INSTRUCTIONS
Step 6
Insert the Spray
Wand Extension into the trig-
ger gun. Press in against the
spring tension and twist into
the lock position. Turn the
Spray Wand Extension Collar
clockwise until tight.
Step 5
Connect the
detergent suction tube to
the pressure washer.
Step 2
Slide the two han-
dle posts into the wheel
brackets and line up the
holes. Insert each of the two
long screws and tighten.
Step 3
Slide the handle
onto the two handle posts and
line up the holes. Insert each
of the two short screws and
tighten.
Step 4
Pull out the locking
slide from the right side of
the trigger gun handle, and
insert the small end of the
high pressure hose into
place. Push the locking slide
back into the trigger gun to
lock the hose in position.
Step 1
Insert the hook of
the lower part of each wheel
bracket into the slot located at
the bottom of the unit, then
slide the upper hook into the
slot located at the top of the
unit until it snaps into place.