Kompernass KH 3460 - Manual (Page 7)

GB
5
5. Assembly
All accessories are coated with a thin
oil film to protect them from corrosion.
Therefore clean all the parts carefully
before using the appliance for the first
time, in accordance with the detailed
instructions found under “8 Cleaning”.
a) Assembling the meat grinder
Unfold the fold out. There you will find
the step-by-step illustrations for
assembling the appliance.
• Place the transport screw
ᕣ with
the hexagonal axle in the mincer
casing
ᕢ.
Ensure that the metal washer
remains on the hexagonal axle.
Without the washer, the screw
would close too fast.
• Now place the cross blade
ᕤ so
that the sharp side is facing the
cutting disc
ᕥ. Warning - the
blade is very sharp!
Attention: the device can get dam-
aged if the cross blade is wrongly
inserted in the opposite direction!
• Choose the appropriate cutting
disc – You can find the discs in the
small recess at the top of the
device (Fig. D).
For this push the cover upwards
and take out the required disc.
• Insert both the edges of the chosen
disc
ᕥ into the slots in the mincer
casing
ᕢ.
• After everything has been assem-
bled correctly, screw on the ring
clamp
ᕦ tightly.
5.
Assembly
• The assembled meat grinder is con-
nected by a bayonet joint to the
motor block
ᕡ:
- Insert the meat grinder into the
motor block. The arrow on the
mincer casing should be on the
symbol “offen” (open) (Fig. A).
- Press in the meat grinder lightly.
Turn the stuffing funnel of the
meat grinder upwards till it is ver-
tical (Fig. B).
- To take it out, once again press
down the meat grinder lightly and
turn the stuffing funnel in the
direction of the symbol ”offen“
(Fig. A). Now you can pull out the
meat grinder.
• Finally place the feed tray
ᕧ on
top on the stuffing funnel.
b) Fixing the sausage stuffer
attachment
Once the meat grinder has been
assembled as described under a):
• Turn open the ring clamp
ᕦ and ...
• Replace the cutting disc
ᕥ with
the sausage disc
ᕩ. This can be
found in the small recess (Fig. D)
on the top of the device. Fix this in
as described in a).
• Now place the sausage stuffer
attachment
µ in front of the
sausage disc, ...
• before screwing on the ring clamp
ᕦ tightly.