Kodak EasyShare C623 - Manual (Page 55)

Troubleshooting
www.kodak.com/go/support 49
Camera ready light status
Picture is too dark. ■ Turn on the flash ( page 11 ).
■ Move so there is no more than 11.8 ft (3.6 m) in wide angle and
6.9 ft (2.1 m) in telephoto between the camera and the subject.
■ Use Fill flash ( see page 11 ) or change your position so light is not
behind the subject.
■ Increase Exposure Compensation ( page 14 ).
Camera does not
recognize
SD/MMC card. ■ Purchase a certified SD/MMC card.
■ Reformat the card ( see page 39 ).
Caution: Formatting a card deletes all pictures and videos,
including protected files.
■ Insert a card into the slot, then push to seat ( page 3 ).
Camera freezes up
when a card is
inserted or
removed. ■ Turn the camera off, then back on. Make sure the camera is turned off
before inserting or removing a card.
Memory card full. ■ Insert a new card ( page 3 ), transfer pictures to the computer
( page 29 ), or delete pictures ( page 19 ).
Memory card and
internal memory
full. ■ Transfer pictures to the computer ( page 29 ), then format the card or
internal memory ( see page 39 ).
Caution: Formatting a card deletes all pictures and videos,
including protected files.
If... Try one or more of the following
Ready light does
not turn on and the
camera does not
work. ■ Turn on the camera ( page 2 ).
■ Install new batteries ( page 1 ) or charge rechargeable batteries.
■ Turn camera off, then back on.
If... Try one or more the following