Kenwood HM-233 - Manual (Page 21)

21
Radio
- Listening to the memorised station -
Listening to the memorised station
Memorising a station
You can store 30 AM and FM stations in memory and recall them at the push of a but-
ton. (Preset tuning)
Note:
The backup function protects the memorised stations for a few hours should there be
a power failure or the AC power lead disconnection.
To recall a memorised station
To scan the preset stations
The stations saved in memory can be scanned automatically. (Preset memory scan)
To clear a memorised station
1
Perform the steps 1 - 3 in "Listening to the Radio" on page 20.
2
Press the MEMORY/SET (MEMORY) button to enter the preset tun-
ing saving mode.
3
Within 5 seconds, press the PRESET ( or ) button to select the
preset channel number.
Store the stations in memory, in order, starting with preset channel 1.
4
Within 5 seconds, press the MEMORY/SET (MEMORY) button to
store that station in memory.
If the "MEMORY" and preset number indicators go out before the station is mem-
orised, repeat the operation from step 2.
5
Repeat steps 1 - 4 to set other stations, or to change a preset sta-
tion.
When a new station is stored in memory, the station previously memorised will
be erased.
Press the PRESET ( or ) button for less than 0.5 seconds to select
the desired station.
Preset channel Frequency and frequency band
1
Press the PRESET ( or ) button for more than 0.5 seconds.
The preset number will flash and the programmed stations will be tuned in se-
quentially, for 5 seconds each.
2
Press the PRESET ( or ) button again when the desired station
is located.
1 Recall the memorised station.
2 Whilst it is displayed, press the MEMORY/
SET (MEMORY) button.
3 Within 5 seconds, press the CLEAR button
on the remote control.