Kompernass AUTOMATIC BREAD MACHINE KH 1172 - Manual (Page 12)

- 10 -
The Bread Baking Machine automatically regulates
the baking temperature and time. Should the bread
still be too light on completion of the baking programme,
it can be after-baked using the programme Baking:
• Press and hold the button Start/Stop ả until the
signal tone sounds and allow the appliance to
cool down with the lid 2 open.
• Press the button Programme selection Ấ several
times to choose the programme Bake.
• To start the after-baking programme, press the
Start/Stop ả button.
• When the desired browning has been obtained,
stop the baking process by pressing the button
Start/Stop
ả until a signal tone is heard.
Keeping warm
When the baking process is complete a signal tone
sounds several times to signify that the bread or other
food item can be removed. In the display appears
7 „0:00“. At the same time a keep warm period
of one hour begins. Excluded are the programmes
Dough and Jam.
End of the programme
Warning!
Before you open the appliance lid 2, remove the
plug from the wall socket to avoid an unintentional
switching on of the appliance. Risk of injury!
Warning!
To avoid the risks from short circuits, thunderstorms
or voltage fluctuations, ALWAYS separate the appliance
from the electrical mains when it is not in use .
• On completion of the programme remove the
baking mould 4 with the help of an oven cloth
or gloves.
Warning!
Always use oven cloths or gloves to remove the
baking mould 4 from the Bread Baking Machine.
• Place the baking mould 4 upside down and,
insofar as the bread does not immediately fall
onto the grill, shift the drive shaft 5 back and
forth a few times from below until the bread falls
out.
Should the kneading hook q become stuck in the
bread, use the supplied kneading hook remover e
to dislodge it:
• Insert it into the round opening of the kneading
hook q on the underside of the warm bread
and jam the kneading hook remover e against
the lower edge of the kneading hook q.
• Then carefully draw the kneading hook q with
the kneading hook remover e upwards. Whilst
doing this one can see at which position in the
bread the wing of the kneading hook q is located.
• Lightly cut the bread at this position and then pull
the kneading hook q out.
Note
Do not use any metal objects which may cause
scratches on the non-stick coating.
Rinse the baking mould 4 with warm water directly
after removing the bread. This prevents the adhesion of
the kneading hook q on the drive shaft 5.
Allow the bread to cool for 15-30 minutes before
eating it.
Attention!
Before cutting the bread, ensure that the kneading
hook q has been removed. The kneading hook q
could be damaged.
IB_KH1172_E4980_LB6.qxd 20.06.2008 10:23 Uhr Seite 10