Koss KS4380-2 - Manual (Page 31)

31
TV Display Setting
Path: General Page
®
TV Display
Selects the aspect ratio of the TV set to be connected.
NORMAL/PS (4:3 Pan & Scan mode):
Used when you connect a normal TV to the system.
Displays a wide picture on the whole TV screen with a
portion (right and left sides of the picture) automatically
cut off.
NORMAL/PS
NORMAL/LB (4:3 Letterbox mode):
Used when you connect a normal TV to the system.
Displays a wide picture with bands displayed on the
upper and lower portions of the screen.
NORMAL/LB
WIDE (16:9 Wide-screen mode):
Used when you connect a wide-screen TV to the system.
WIDE
Notes:
Some wide-screen discs that do not permit Pan &
Scan mode playback are automatically played in
Letterbox mode.
Depending on the DVD, 4:3 Letterbox may be
selected automatically instead of 4:3 Pan & Scan and
vice versa.
You must also set the screen mode on your wide-screen
TV to “FULL”.
If WIDE is selected and a normal TV is connected,
16:9 content will appear distorted during playback
(objects look thin).
TV Type Setting (Multi/NTSC/PAL)
If you live in North America your TV broadcast system is
NTSC, your TV set is either a NTSC TV or a multi system
TV, and the DVD movies you buy or rent will be labeled
NTSC system. The initial Default TV Type setting of this
system is “NTSC”. This setting will allow NTSC discs to play
properly on NTSC TVs. If you live in North America no
further adjustment is necessary. You can skip to the next
section.
If you wish to change the TV Type setting follow the
3 steps below.
1. Press SETUP button to enter SETUP MENU. Use
< / > to select GENERAL SETUP, and then press
ENTER button.
2. Highlight TV TYPE using Щ / Ъ , then press > button
to go to the right option list. Select NTSC or PAL
using
Щ
/
Ъ
, then press ENTER to confirm your
selection.
3. Press SETUP again to exit SETUP MENU.
Note:
When the power is switched off, or the disc drawer is
opened, the TV type will automatically revert back to
the initial Default setting.
Video Out
Select the color video type and switch mode to fit your
connector type:
SCART/CVBS: Select when using CVBS composite Video
Output (if S-Video connector is provided.)
YUV: Select when using Component Video Outputs.