Kenwood KVT-532 - Manual (Page 4)

4 | KVT-512/KVT-532DVD
Connecting Wires to Terminals
– +
PRK SW
USB connector
USB device
(commercially available)
FUSE ( 15A )
To connect the Kenwood navigation system,
consult your navigation manual.
To use the steering wheel remote control feature, you need to an
exclusive remote adapter (not supplied) matches your car is required.
For the sake of safety, be sure to connect the parking sensor.
Connect to the vehicle's parking brake detection
switch harness.
Battery wire (Yellow)
Ignition wire (Red)
Steering remote control input (Light Blue/Yellow)
To steering remote
If no connections are made, do not let the cable come out from the tab.
Connect to the terminal that is grounded when either
the telephone rings or during conversation.
Mute wire (Brown)
Connect to vehicle’s reverse lamp harness when
using the optional rear view camera.
Reverse sensor wire (Purple/White)
Parking sensor wire (Light Green)
If you connect the ignition wire (red) and
the battery wire (yellow) to the car chassis
(ground), you may cause a short circuit, that
in turn may start a fire. Always connect those
wires to the power source running through
the fuse box.
When using the optional power amplifier,
connect to its power control terminal.
Power control wire (Blue/White)
Depending on what antenna you are using,
connect either to the control terminal of the motor antenna, or to the
power terminal for the booster amplifier of the film-type antenna.
Motor antenna control wire (Blue)
To car light control switch
Dimmer control wire (Orange/White)
Ignition key
switch
ACC
Car fuse box
(Main fuse)
Battery
Car fuse box
Ground wire (Black) - (To car chassis)