Kicker SX500.2 - Manual (Page 12)

23
SX .2 Series Amplifiers
Opera
tion
hi-pass MENU - Here is where you adjust the high pass
crossover.
Press the ENT key to enter the
HI-PASS menu.
Use the UP and DOWN keys to
scroll through frequency and slope
and press the ENT to select the one
you want to adjust.
FREQUENCY selects the crossover point and can be set at any
1/12th octave frequency from 10 Hz to 16 kHz.
(
10 Hz to 16132 Hz )
Use the UP and DOWN keys to
select your frequency. Press the ESC
key to return to the HI-PASS menu.
SLOPE selects the rolloff of the crossover and can be set
from OFF to 36 dB in 6 dB steps.
Use the UP and DOWN keys to
select your slope. Press the ESC
to return to the HI-PASS menu.
When you are done adjusting the
EQ press the ESC key while in the
EQ menu to return to the MAIN
menu.
NOTE...
While adjusting the HI-PASS crossover you will notice the
hpf indicator on the ISIS VFD display is lit. This indicates
you are in the HI-PASS crossover menu.
The KICKER SX amplifier monitors and prevents any high
pass crossover point from being any closer than 1/3 octave
from the low pass crossover point. If you cannot set the high
pass crossover where you want then check the
LPF indicator
and see if it is flashing. If it is then you need to go to the
LO-PASS menu and lower the low pass crossover point.
This is done as a safety precaution to prevent a notch
filter condition.
HOME ENT ESC
HOME ENT ESC
HOME ENT ESC
HOME ENT ESC
HOME ENT ESC
22
SX .2 Series Amplifiers
Opera
tion
Lo-Pass MENU - Here is where you adjust the low pass
crossover.
Press the ENT key to enter the
LO-PASS menu.
Use the UP and DOWN keys to
scroll through frequency and
slop[e. Press the ENT to select the
one you want to adjust.
FREQUENCY selects the crossover point and can be set at any
1/12th octave frequency from 30 Hz to 20 kHz.
(
30 Hz to 20325 Hz )
Use the UP and DOWN keys to
select your frequency. Press the
ESC to return to the LO-PASS
menu.
SLOPE selects the rolloff of the crossover and can be set
from oFF to 36 dB in 6 dB steps.
Use the UP and DOWN keys to
select your slope. Press the ESC to
return to the LO-PASS menu.
When you are done adjusting the
EQ press the ESC key while in the
EQ menu to return to the MAIN
menu.
NOTE...
While adjusting the LO-PASS crossover you will notice the
LPF indicator on the ISIS VFD display is lit. This indicates
you are in the LO-PASS crossover menu.
The KICKER SX amplifier monitors and prevents any low pass
crossover point from being any closer than 1/3 octave from
the high pass crossover point. If you cannot set the low pass
crossover where you want then check the
HPF indicator and
see if it is flashing. If it is then you need to go to the HI-PASS
menu and raise the high pass crossover point.
This is done as a safety precaution to prevent a notch filter
condition.
HOME ENT ESC
HOME ENT ESC
HOME ENT ESC
HOME ENT ESC
HOME ENT ESC