Krell Industries RESOLUTION 1 - Manual (Page 9)

continued ᮣ
5
To Remove the Resolution Loudspeaker from the Shipping Box
The shipping box is designed to open safely and easily. Inside the box, the
Resolution loudspeaker is enclosed in a protective sleeve, and is further protected
by foam pads. The only tool you need is a box cutter, to remove the loudspeaker
from the shipping box.
Note
Save all packing materials. If you need to ship a Resolution Series loudspeaker in the future,
repack the unit in its original packaging to prevent shipping damage.
Follow the steps below to unpack any loudspeaker model:
1. Set the shipping box right side up using the arrows on the box as a guide.
two people needed
2. Use a box-cutting knife and slit the tape all along the top seams
of the outer carton.
3. Open the flaps to reveal the inner carton.
4. Slit the tape along the top seams of the inner carton and open the flaps.
If you are unpacking a Resolution 3, skip to Step 6.
If you are unpacking a Resolution C, skip to page 7:
5. Remove the foam pad containing two cardboard boxes, marked “accessories”
and “grille”, and set aside.
Continue the unpacking process for the Resolution 1, 2, or 3.
6. The loudspeaker is lying on its side. The top and bottom of the loudspeaker
are inset into foam pads. These cannot be removed while the loudspeaker is in
the box. Remove the moveable foam pads protecting the sides of the loudspeak-
er.
7. Locate the foam pad labeled TOP: this pad protects the top of the loudspeaker.
Carefully lift the loudspeaker carton to a standing position, upside down.
Orientation: the foam pad on the floor is labeled TOP. Make certain that the
loudspeaker stays inside the carton as you bring it to the vertical position.
two people needed
8. Kneel down and grasp the foam pad labeled TOP.
Krell Resolution 1, 2, 3, and C Loudspeakers
(SECTION TWO: Unpacking and Placement continued)