Kambrook ARCTIC KFA211 - Manual (Page 7)

7
7. Thread the screw through the small
holes of both the front and back grilles,
and tighten using the nut provided.
Fig. 2
To Operate the Arctic
Desk Fan
Plug the cord into a 230V or 240V power
point and switch on.
NOTE: To avoid an electrical circuit
overload, it is recommended that no
other appliances are plugged into
the same circuit as your fan, when it
is in use.
Use the Controller Switch to select the
desired air flow speed setting.
0 – The fan is in the ‘OFF’ position
1 – Low
2 – Medium
3 – High
Fig. 3
(KFA210 only offers 2 settings)
Setting the Oscillation
The oscillation function works in all air
flow settings.
Press down the Oscillation button to
activate. The fan will begin to oscillate
from side to side.
Lift the Oscillation button to stop the fan
from oscillating.
NOTE: The Oscillation button is
located behind the Rear Grille, on
the Motor head housing.
Adjustable Tilting Head
The Arctic Desk Fan incorporates
an Adjustable Tilt Head for greater
air coverage.
To adjust the angle of the head on the
KFA210, loosen the Control Knob located
beneath the Motor head housing, select
the required tilt angle, then tighten the
Control Knob.
To adjust the angle of the head on the
KFA211 and KFA213, while securely holding
the shaft of the fan body, simply lift or
lower the Motor head housing, the head
will click as it is being adjusted.
Care and Maintenance
Always switch the Arctic Desk Fan off,
prior to cleaning the housing, base, grilles
and blades.
To clean the outside of the fan, wipe the
exterior with a soft, damp cloth. Never use
an abrasive cleaner.
When not in use, store the fan (preferably
in its original box) in a cool, clean and
dry location.