Kompernass KH 1142 - Manual (Page 7)

- 5 -
Removing/replacing the pouring sieve
• Open the lid w .
• Press from the inside against the pouring sieve q
and at the same time push it upwards.
• Clean the pouring sieve q with a lightly moistened
dishcloth and under running water.
• After cleaning, insert the pouring sieve q from
above and press it firmly into place. Ensure that
the bar on the pourer sieve
q is gripped in the
guide rail.
• Should the scale deposits in the pourer sieve q
be firmly settled, lay it in a water-vinegar solution,
with a ratio of 6:1, for a few hours. The scale
deposits will dissolve themselves. Rinse the pourer
sieve
q with lots of clear water.
Storage
Allow the appliance to cool off completely before
putting it into storage.
• Wind the power cable
u around the holder on
the bottom of the appliance.
• Store the appliance in a dry place.
Disposal
Do not dispose of the appliance in your
normal domestic waste.
Dispose of the appliance through an approved dis-
posal centre or at your community waste facility.
Observe the currently applicable regulations.
In case of doubt, please contact your waste disposal
centre.
Dispose of the packaging materials in an
environmentally responsible manner.
IB_KH1142_E4528_LB6 27.06.2008 11:07 Uhr Seite 5