KTM Chassis 690 SMC - Manual (Page 2)

Ktm 690E and Smc instructions.doc 3528
Loosen the key bolts on both sides to help alignment Move the top plate around until it’s centered
This is the correct tower pin height for this model.
Be sure the tower pin does not extend through the slot
too far as it can make contact with the damper body.
Keep the tower pin greased in the hole.
Install the black SUB mount first using the rear set of
holes on the triple clamp and tighten the Allen bolts.
Then install the stock lower perches and tighten.
Perches can be reversed for optional bar positions.
Cut the stock plastic key shrouds along the dotted lines
until they match your frame to your satisfaction.
Parts are silver in this photo to show contrast for mounting ease.