Kompernass PFLK15 - Manual (Page 4)

TECHNICAL INFORMATION
Electricity supply: 230 V ~
Power consumption: 15 W
Frequency: 50 Hz
max. soldering tip temperature: approx. 300° C
BEFORE USING FOR THE FIRST TIME
½ Please read the safety advice for electric tools in the section on "Safe operation".
½ Before using the tool for the first time check that your mains voltage agrees with that on the rating plate.
½ Before heating the tool check that the soldering tip is firmly seated - the clamping screw must be fully tightened.
½ Connect the soldering pencil to the mains supply.
½ When removing the soldering tip make sure that the soldering pencil is switched off and do not use too much force. Slide a new soldering tip
fully in so that it hits the stop.
½ Do not heat up the soldering pencil without a tip in place.
½ After use let the soldering pencil cool down in air only. Under no circumstances quench the tip in water!
½ Place the soldering pencil in the stand during any pauses in your work.
½ To avoid the risk of fire we recommend that you place the soldering pencil down only in the special stand or on a fire-resistant support pad.
½ Do not use the soldering pencil if the mains cable is damaged. For any repairs always use an electrical equipment repair centre or the service
centre indicated for your country.
4
SOLDERING PENCIL PFLK 15 For soldering electronic components and circuit boards