Kenwood VC-H1 - Manual (Page 11)

OPERATING BASICS
7
SWITCHING POWER ON/OFF
1 Slide the PWR switch upward to turn
the power ON.
• The TX/RX indicator lights green.
2 To turn the power OFF, slide the PWR
switch downward.
SELECTING A SSTV MODE
To correctly transmit or receive images,
you and the other party have to select
the same SSTV mode. So first consult
with your party about the mode to be
used. You can select either Robot
(color) 36 or Fast FM; the factory default
is Robot (color) 36.
Note: The Fast FM mode is available only when
using a TM-255, TM-455, TM-733, TM-V7, or
TM-G707 transceiver; 9600 bps must be selected on
the transceiver as the data transfer rate. For details,
contact your authorized KENWOOD dealer,
customer service, or service center. In Fast FM
mode, the VC-H1 does not output audio from the
speaker while receiving an image, and does not
function as a speaker microphone.
Press [TX]+ POWER ON to switch the
mode.
• The FAST FM indicator shows which
mode is selected.
Lights red: Fast FM
Goes out: Robot (color) 36
The VC-H1 is also compatible with the
following modes. See “RECEIVING
IMAGES” {page 10} and “COMPUTER
CONTROL” {page 17}.
• Robot (color) 72 • AVT 90
• AVT 94 • Scottie S1
• Scottie S2 • Martin M1
• Martin M2