Kompernass KH 3006 - Manual (Page 4)

- 2 -
Appliance description
q Laser appliance
w ON/OFF button
e Spirit level for horizontal lines
r Spirit level for vertical lines
t Laser lens
y Rotating plate with degree scale
u Marking arrow
i Fastening pins
o Fixing points on the laser appliance
a Fixing points on the rotating plate
s Battery compartment
(on the rear side)
Inserting the batteries
1. Open the battery compartment s .
2. Insert two batteries of Type AAA/LR03
into the battery compartment s . Comply
with the polarity markings in the battery
compartment
s .
3. Close the battery compartment s .
Utilisation
Switching On and Off
1. To switch the laser appliance q on,
press the ON/OFF w button.
2. To switch the laser appliance q off,
press the ON/OFF w button once
again.
Utilisation on a wall
1. Remove the laser appliance q from
the rotating plate. The laser appliance
clings to the rotating plate
y magneti-
cally.
2. Place the rotating plate y at the posi-
tion on the wall from where you wish
to draw the alignment line.
3. Secure the rotating plate y to the wall
in that you take both fastening pins i
from the sides of the appliance and you
press them through the fixing points on
the rotating plate
a and into the wall
(See Fig.
Ạ
).
Notice:
The fastening pins
i can be inserted
into most upper surfaces, such as wood,
plaster or mortar. Alternatively, espe-
cially with other upper surfaces, you
could also use adhesive tape for secu-
ring the rotating plate
y .
You can also secure the laser appliance
q without the rotating plate, in that
the fastening pins i are inserted
through fixing points on the laser
appliance
o itself.
4. Place the laser appliance q onto the
rotating plate y .
5. Turn the laser appliance q with the
marking arrow u into the desired
direction.
6. Switch the laser appliance q on, by
pressing the ON/OFF button w .
The laser beam appears on the wall in the
direction of the marking arrow
u .
Plumb-line
To mark a plumb-line, turn the laser
appliance
q on the rotating plate y
with the marking arrow u pointing in
the direction in which the laser marking
is to be indicated, then finely adjust it
vertically with the spirit level
r .
IB_KH3006_BL5778_EN.qxd 12.06.2007 11:46 Uhr Seite 2