Kenwood KDC-5027 EN - Manual (Page 27)

English | 27
Installation
Screwing the Faceplate on the Unit
If you want to fasten the faceplate to the main
unit so that it does not fall off.
1 Refer to the section 'Removing the hard rubber
frame' (page 28) and then remove the hard
rubber frame.
2 Drop open the faceplate by pressing the Release
button.
3 Tighten the screws (ш2.6 Ч 12 mm) (Accessory
4) in the holes shown on the diagram.
Accessory 4
4 Tighten the screws (ш2 Ч 4 mm) (Accessory 5) in
the holes shown on the diagram.
Accessory 5
5 Tighten the screws (ш2 Ч 6 mm) (Accessory 6) in
the holes shown on the diagram.
Accessory 6
• Never insert the screws in any other screw hole than the
one specified. If you screw them in another hole, it will
contact and may cause damage to the mechanical parts
inside the unit.
• Make sure that the unit is installed securely in place. If
the unit is unstable, it may malfunction (for example, the
sound may skip).
Installation
Firewall or metal support
Screw (M4X8)
(commercially available)
Self-tapping screw
(commercially available)
Metal mounting strap
(commercially available)
Bend the tabs of the
mounting sleeve with a
screwdriver or similar utensil
and attach it in place.