Kustom KPM 8420T - Manual (Page 5)

Ef
fects
1
Ef
fects
2
T
reble Mid
Bass
Monitor
Main Pad
Line/Mic
Line/Mic
Pad
Line/
Inst
1 2
3
4 5 6 7 8 9 10
LINE/MIC Input Jacks:
PAD Switch:
LINE/INSTRUMENT Buttons (Channels
7&8 Only):
MAIN
MONITOR
BASS
MID
TREBLE
EFFECTS 2
EFFECTS 1
Volume Control:
Volume Control:
Control:
Control:
Control:
Control:
Control:
These are combination input jacks capable of
receiving a Male-XLR for Balanced inputs such as
microphones or a Male ¼” Plug for Line level and
Instrument level devices.
This switch attenuates the input signal by 12db in
the out position. Press in when more input signal
gain is needed. If the input sounds distorted, then
use the out position.
When the button is out, the ¼” input is configured
to receive a standard Line level input such as a
High-Z microphone, keyboard, drum machine, etc.
When this button is pressed, the input is configured
to receive an input from an electric or acoustic
guitar. No additional preamps are necessary to
amplify acoustic guitars with
pickups.
Adjusts the volume of the individual channels to
the MAIN output section.
Adjusts the volume of the individual channels to
the MONITOR output section.
Adjusts the amount of bass or low frequencies of
the individual channels to the main output section.
(NOTE: This control does not affect the monitor
signal).
Adjusts the amount of mid-range frequencies of the
individual channels to the main output section.
(NOTE:
).
Adjusts the amount of Treble or high frequencies
of the individual channels to the main output
section. (NOTE:
).
This control adjusts the amount of signal sent to the
EFFECTS 2 master section. Note: This control is
post fader, meaning the Effects 2 control gets it's
signal from the MAIN volume control. The MAIN
volume control must be turned up to allow signal
to flow to the EFFECTS 2 Control.
This control adjusts the amount of signal sent to the
EFFECTS 1 master section. Note: This control is
post fader, meaning the Effects 1 control gets it's
signal from the MAIN volume control. The MAIN
volume control must be turned up to allow signal
to flow to the EFFECTS 1 Control.
This control does not affect the monitor
signal
This control does not affect the
monitor signal
piezo
CHANNELS
5