KITCHENAID Bottom-Mount Built-In Refrigerator - Manual (Page 8)

8
3. Take the new cartridge out of its packaging and remove
protective cover from o-rings.
4. Slide the cartridge cap onto the new cartridge. See
illustration in Step 2.
5. With cartridge cap in the vertical position, push the new filter
cartridge into the base grille until it stops. Rotate the cartridge
cap clockwise to a horizontal position. Discard the first three
batches of ice produced after replacing the filter.
Using the Ice Maker Without the Water Filter
You can run the ice maker without a water filter cartridge. Your ice
will not be filtered.
1. Remove the base grille water filter cartridge.
2. Slide the cartridge cap off the end of the filter cartridge. DO
NOT DISCARD THE CAP. With the cartridge cap in the
vertical position, insert the cap into the base grille until it
stops.
3. Rotate the cartridge cap to a horizontal position. The
cartridge cap might not be even with the base grille.
Refrigerator Shelves
The shelves in your refrigerator are adjustable to meet your
individual storage needs.
Storing similar food items together in your refrigerator and
adjusting the shelves to fit different heights of items will make
finding the exact item you want easier. It will also reduce the
amount of time the refrigerator door is open, and save energy.
Shelves and Shelf Frames
To remove and replace a shelf/frame:
1. Remove the shelf/frame by tilting it up at the front and lifting it
out of the shelf supports. Pull shelf straight out.
2. Replace the shelf/frame by guiding the rear shelf hooks into
the shelf supports. Tilt the front of the shelf up until the rear
shelf hooks drop into the shelf supports.
3. Lower the front of the shelf and check to make sure that the
shelf is securely in position.
Deli Locker
The Deli Locker is designed to provide colder storage
temperatures than the average refrigerator temperature. The air in
the drawer can be set to the National Livestock and Meat Board
recommended storage temperature range of 28°- 32°F (-2°- 0°C)
for fresh meats. It is also large enough to store large party trays.
To remove and replace the Deli Locker drawer:
1. Remove the deli locker by rolling it out to the stop. Lift up
front slightly. Pull deli locker out the rest of the way.
2. Replace by positioning the rollers between the front roller of
track and the track. Push deli locker up and onto track. Slide
back until stops.
Deli Locker Temperature Control
The Deli Locker temperature control allows you to adjust the
storage temperature of the Deli Locker. Cold air flows into the
Deli Locker through an air duct between the freezer and the
refrigerator. Setting the control allows more or less cold air
through the air duct. Set the control to “COLD” to close the air
duct.
IMPORTANT: If a food item freezes in the Deli Locker, utility
drawer, or crisper, turn the Deli Locker temperature control to
“COLD.”
Important information to know about glass shelves
and covers:
Do not clean glass shelves or covers with warm water when
they are cold. Shelves and covers may break if exposed to
sudden temperature changes or impact, such as bumping.
For your protection, tempered glass is designed to shatter
into many small, pebble-size pieces. This is normal. Glass
shelves and covers are heavy. Use special care when re-
moving them to avoid impact from dropping.