Kenmore 87002 - Manual (Page 11)

10
HOW TO SET THE OVEN CONTROLS
(Please also see the following pages for more detail)
BEEPS DURING OVEN SETTINGS
♦ ONE BEEP: Oven accepts the entry.
♦ TWO BEEPS: Oven does not accept the
entry. Please check and try again.
SETTING THE CLOCK
The clock works in 12-hour cycle. When the
oven is first plugged in, the display will
briefly show “ENTER CLOCK TIME”, you
can set the clock time now or later. To set the
clock time later,
1. Press CLOCK pad.
2. Use the numeric pads (in the natural
sequence of time) to enter clock time
3. Press CLOCK to confirm.
MICROWAVE COOKING
Microwave cooking allows you to customize
cooking power and time. First, you select a
power level by pressing the POWER LEVEL
pad a number of times (see the table below).
Then you set the cooking time using the
numeric pads, before pressing the START
pad.
Press POWER pad to select cooking
power
Press Power Description
once 100%(P-100) High
twice 90%(P-90)
3 times 80%(P-80)
4 times 70%(P-70)
Medium
High
5 times 60%(P-60)
6 times 50%(P-50) Medium
7 times 40%(P-40)
8 times 30%(P-30) Med.
Low/Defrost
9 times 20%(P-20)
10 times 10%(P-10) Low
11 times 0%(P-00)
Suppose you want to cook for 5 minute at
60% power level.
1. Press POWER LEVEL pad 5 times
2. Press number pads to enter cooking time
until the correct cooking time (5:00) is
displayed.
3. Press START pad.
NOTE:
1. If you want to temporarily stop a cooking
session, press the STOP/CANCEL pad once
and then you can start the cooking again by
press START; or press the STOP/CANCEL
twice to cancel the cooking program altogether.
2. After the cooking time ends, the system will
beep four times and END is displayed. Before
starting another cooking session, press
STOP/CANCEL pad to clear the display and
reset the system.
GRILL
Grill cooking is particularly useful for thin
slices of meat, steaks, chops, kebabs,
sausages and pieces of chicken. It is also
suitable for hot sandwiches and au gratin
dishes.
Suppose you want to program grill cooking
for 12 minutes use the top and bottom
heaters,
1. Make sure the system is reset by