Kambrook KCT110 - Manual (Page 8)

8
Operating Instructions
Before First Use
Remove any packaging material
and promotional labels before using
your Kambrook Electric Teapot for the
first time.
It is recommended that before first
use, you fill the Kambrook Electric
Teapot to the maximum level with
cold tap water, bring to the boil and
discard the water.
Your Kambrook Electric Teapot will
only operate when positioned on the
power base with the ON/OFF switch
in the ‘ON’ position. Ensure the power
plug is connected into a power point
and switched on.
The Kambrook Electric Teapot will
automatically switch ‘OFF’ once the
water is boiled.
Operation of Your Kambrook
Electric Teapot
1. To fill the Kambrook Electric
Teapot, remove it from the power
base and open the lid by pulling
up. (see Fig. 1)
Fill with the desired amount of
water. Never fill the Kambrook
Electric Teapot above the ‘MAX’
mark, which is indicated by the
‘MAX’ mark on the internal wall.
NOTE: Do not fill above the
MAX mark as boiling water
may splash out from the
Kambrook Electric Teapot.
2. Add the tea leaves to the basket
and place back inside the Teapot.
3. Ensure the lid is locked firmly into
the Teapot before placing the
Kambrook Electric Teapot on the
power base.
4. Place the Kambrook Electric
Teapot firmly onto the power base.
Plug the power plug into 230V or
240V power outlet and switch ‘ON’.
5. Press the On/Off switch to the
‘ON’ position. The power ‘ON’ light
will illuminate.
NOTE: Do not remove the
Kambrook Electric Teapot
from the power base during
operation. Ensure the Teapot
has switched off before
removing the Teapot from the
power base.
6. The Kambrook Electric Teapot
will automatically switch ‘OFF’
once the water has boiled. Lift the
Kambrook Electric Teapot from the
power base and pour the water.
Take care to hold the Kambrook
Electric Teapot level, especially
when filled to the maximum level.
To re-boil it may be necessary to
wait for a few seconds to allow
the control to reset.
7. To refill tea, remove the lid from
the Teapot and ensure that the
basket has cooled down before
removing. We recommend that
you use tongs or oven mitts
when removing.
Fig. 1
KCT110_IB_FA.indd 8 6/11/09 1:26 PM