Kambrook KSC650 - Manual (Page 4)

Always ensure the Kambrook Profile Banquet
Slow Cooker is properly assembled before
connecting to the power outlet and operating.
Follow the instructions provided in this book.
The appliance is not intended to be operated
by means of an external timer or separate
remote control system.
Do not place anything, other than the lid, on
top of the Kambrook Profile Banquet Slow
Cooker when assembled, when in use and
when stored.
•
•
•
Always switch the Kambrook Profile Banquet
Slow Cooker to the OFF position, then switch
off at the power outlet, then unplug and
allow to cool, if appliance is not in use, before
cleaning, before attempting to move the
appliance, dissembling, assembling and when
storing the appliance.
Keep the appliance clean. Follow the cleaning
instructions provided in this book.
•
•
IMPORTANT SAFEGUARDS FOR ALL ELECTRICAL APPLIANCES
Fully unwind the power cord before use.
Do not let the power cord hang over the edge
of a bench or table, touch hot surfaces or
become knotted.
To protect against electric shock do not
immerse the power cord, power plug or
stainless steel housing in water or any other
liquid.
The appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities, or
lack of experience and knowledge, unless they
have been given supervision or instruction
concerning use of the appliance by a person
responsible for their safety.
Children should be supervised to ensure that
they do not play with the appliance.
This appliance is for household use only. Do
not use this appliance for anything other
than its intended use. Do not use in moving
vehicles or boats. Do not use outdoors.
Misuse may cause injury.
•
•
•
•
•
•
It is recommended to regularly inspect the
appliance. Do not use the appliance if the
power cord, power plug or appliance becomes
damaged in any way. Return the entire
appliance to the nearest authorised Kambrook
Service Centre for examination and/or repair.
Any maintenance other than cleaning should
be performed at an authorised Kambrook
Service Centre.
The installation of a residual current device
(safety switch) is recommended to provide
additional safety protection when using
electrical appliances. It is advisable that a
safety switch with a rated residual operating
current not exceeding 30mA be installed in
the electrical circuit supplying the appliance.
See your electrician for professional advice.

CAUTION: HOT SURFACES
DURING AND AFTER USE.
•
•
•
KSC650_IB_FA.indd 4 4/3/09 3:43:37 PM