Kodak EASYSHARE W820 - Manual (Page 75)

Troubleshooting and support
www.kodak.com/go/support 68
I didn’t connect to my network the first time I turned on my frame. Can I
do it now?
Yes, you can.
1 Tap Home
→
Settings
.
Slide to highlight Network, then tap Select.
2 Highlight Scan for wireless networks, then tap OK.
3 Continue with step 1 on page 5 .
Picture frame problems
If... Try one or more of the following
Frame cannot connect
to the wireless network
—“Wireless network
not found” appears. ■ Make sure you have a wireless router and that it is broadcasting
the SSID, or enter the SSID manually.
■ Make sure you are within the operating range of the network.
Move the frame into the same room with the router.
■ Make sure your frame is using the latest firmware. Check
www.kodak.com/go/digitalframesupport for updates.
■ If your network security is enabled ( See page 8 ), enter your security
key (WEP or WPA). The person who set up your network can help
you with this information.
Frame does not
turn on. ■ Make sure the power cable that was included with your frame is
connected securely (see
page 2 ).
■ Unplug the power cable for 5 seconds, then reconnect the cable.
Press and hold the power button (for about 2 seconds), then
release.