Kompernass Parkside XQ2 - Manual (Page 6)

Switching on
j Push the On / Off switch P upwards into
position “1”.
Switching off
j Push the On / Off switch P downwards into
position “0”.
L Vacuum dust extraction
Warning! Danger of fire! There is the danger of
fire when working with electrical devices that have
a dustbox or can be connected to a vacuum cleaner.
Under certain conditions the wood dust in the dust
extraction bag (or in the vacuum‘s dust bag) may
ignite, e.g. as a result of flying sparks generated
when abrading metals or metal objects left in wood.
This can happen particularly if the wood dust is
mixed with paint residue or other chemicals and the
abraded particles are hot from prolonged abrasion.
Therefore you must empty the dust box and the
vacuum cleaner’s dust bag before taking a break or
stopping work and always avoid overheating of the
abraded particles and the tool.
Wear a dust mask!
Adapter for internal vacuum extraction
Connection:
j Slide the dust extraction box T on to the adapter
port U until you hear it engage.
Removal:
j Press the release button
R of the dust extraction
box T and withdraw it towards the rear of the
device.
j Tap it on a robust object.
Adapter for external vacuum extractor
Connection:
j Push the adapter for external vacuum extraction W
into the adapter port U . If it is necessary to use
the reducer piece E push the reducer piece into
the adapter for external vacuum extraction W .
j Slide the hose of a suitable dust extraction de-
vice approved for that purpose (e.g. a workshop
vacuum cleaner) on to the adapter for external
vacuum extraction
W or the reducer piece E .
Removal:
j Pull the hose of the dust extraction device off the
adapter for external vacuum extraction
W .
j Pull off the adapter for external vacuum
extraction
W .
L Attaching / detaching sanding sheets
Attaching
j Sanding sheets are easily attached to the
backing plate
O by means of the hook and pile
fastening.
Detaching
j Simply pull the sanding sheet off the backing
plate
O (see Fig. C).
L
Rotating the backing plate
j Switch off the tool.
j Rotate the backing plate O into the desired
position (see Fig. D).
L
Advice on use
j Switch the tool on before placing it against the
workpiece.
j Apply light sanding pressure.
j Advance the tool at an even rate.
j Work in parallel and overlapping widths.
Sanding and surfaces
The sanding output and the quality of the surface
finish are determined by the grade of grit on the
sanding sheet.
Tips and tricks
j Change sanding sheets at the appropriate time.
j Avoid sanding metal and other materials with the
same sanding sheet.
8 UK / IE
Operation