beautypg.com

Maintenance instructions – Keys Fitness CardioZone CZ PRO User Manual

Page 15

background image

Maintenance Instructions

15

WARNING! Before performing any maintenance to your treadmill, always unplug the power cord from

the surge protector.

CLEANING

Routine cleaning of your CardioZone treadmill will extend the life of your treadmill. WARNING! To

prevent electrical shock, be sure the power to the treadmill is OFF and the unit unplugged from the wall

electrical outlet before attempting any cleaning or maintenance.

AFTER EACH WORKOUT: Wipe off the console and other treadmill surfaces with a clean, water

dampened soft cloth to remove excess perspiration. USE NO CHEMICALS.

WEEKLY: Use of a treadmill mat is recommended for ease of cleaning. Dirt from your shoes contacts

the belt and eventually makes it to underneath the treadmill. Vacuum underneath treadmill once a week.

DECK LUBRICATION

The walking belt has been pre-lubricated at the factory. However, it is recommended that the walking

board be checked periodically for lubrication to ensure optimal treadmill performance.

Every 30 days or 30 hours of operation, lift the sides of the walking belt and feel the top surface of the

walking board as far under as you can reach. If you feel signs of silicone, no further lubrication is

required. If it feels dry to the touch, follow the instructions below.

CardioZone recommends “Lube N Walk” for cleaning and lubricating the treadmill belt and deck. Ask

your retailer or call CardioZone at (877) 855-0003. You may also use silicone such as “Napa 8300” (avail-

able at most Napa stores).

TO APPLY LUBRICANT TO THE WALKING BOARD

1) Position the walking belt so that the seam is located on top and in the center of the center of the walk-

ing board.

2) Insert the spray nozzle into the spray head of the lubricant can.

3) While lifting the side of the walking belt, position the spray nozzle between the walking belt and the

board approximately 6” from the front of the treadmill. Apply the silicone spray to the walking board,

moving from the front of the treadmill to the rear. Repeat this on the other side of the belt. Spray

approximately 4 seconds on each side.

4) Allow the silicone to ‘set’ for one minute before using the treadmill.

WARNING: Do not over-lubricate the walking board. Excess lubricant should be wiped off with a clean

towel.