Kenmore 125.15887800 - Manual (Page 7)

7
ASSEMBLY
Choose a good, cleared assembly area and
get a friend to help you put your smoker
together. Lay cardboard down to protect
smoker finish and assembly area.
CAUTION: Some parts may contain
sharp edges. Wear protective
gloves if necessary.
Note: With the help of a friend, turn the
smoker cabinet upside down.
Step 1
For each leg, line up the holes and insert three
1/4-20 X 5/8” bolts, nuts are pre-welded to the
cabinet. Securely tighten the bolts.
Note: With the help of a friend, turn the
smoker body to its upright position. Try
to minimize stress on legs.
Step 2
Install air vent tube by lining up the holes with
the back panel holes on the inside of smoker
cabinet. Insert two 10-24 X 1” bolts from the
outside of the cabinet.
Step 3
From inside the cabinet, slide washers onto
bolts and thread 10-24 flange nuts onto bolts.
Securely tighten nuts.
Note: Line up the side handle with the
corresponding holes on the side of the
cabinet as shown.
Step 4
Attach side handles by using two
10-24 X 5/8” bolts through handle loops.
Securely tighten. Repeat for other handle.