Kawasaki VULCAN 1700 VOYAGER - Manual

Installation Instructions
Assembly Instructions
Description: CB Radio Kit Model: Vulcan 1700 Voyager
Part Number: K10400-037 Approximate
Assembly Time:
60 min.
Installation of this accessory should be performed by a qualified technician with the proper tools and
equipment.
If you are in doubt as to any part of the installation, please ask your authorized Kawasaki dealer to
complete the installation. Please note that Kawasaki cannot assume any responsibility for damage
resulting from incorrect installation.
Parts List Tools Required:
Seq. Description Qty Tool Description
1. CB Radio Module Assembly 1 ƒ Drill Motor
ƒ Scribe
ƒ 1/16” Drill Bit
ƒ 7mm (1/4”) Drill Bit
ƒ 5mm Hex Head Driver
ƒ Socket Driver
ƒ 10mm Socket
ƒ Philips Head Screwdriver
2. M6 x 30mm Bolts 2
3. CB Antenna Cable 1
4. CB Antenna Base 1
5. M6 x 20mm Philips Head Bolt 1
6. CB Ground Strap 1
7. M6 Lock Nuts 2
8. Lock Washer 1
9. Belleville Washer 1
10. M6 Cap Nut 1
11. Cable Ties, 6 inch 8
12. Cable Tie, 14.5 inch 1
13. CB Antenna Mast 1
14. Star Washer 1
Installation Preparation
Parts Removal
z Set bike securely on side stand on level ground. Switch off
ignition and remove key.
z Refer to the VN1700 Voyager Service Manual and remove the
fairing. Remove the front and rear seats, fairing and left fairing
lower cover (black piece).
z Open the trunk and remove the tray by pressing the center of
the four lock rivets.
z Remove the fuel tank mounting bolts and lift the tank to expose
the frame.