Kodak MDV434K - Manual (Page 8)

English
8
Connections
IMPORTANT!
– If your TV only has a single
Antenna In jack (or labeled as 75
ohm or RF In,) you will need an RF
modulator in order to view the DVD
playback on the TV. See your
electronics retailer for details on RF
modulator availability and
operations.
Using an accessory RF modulator
1
Use the composite video cable (yellow) to
connect the DVD Player’s
CVBS jack to
the video input jack on the RF modulator.
2
Use the RF coaxial cable (not supplied) to
connect the RF modulator to your TV’s
RF jack.
AUDIO IN
R L VIDEO
IN
TO TV INT IN
CH3 CH4
2
1
RF coaxial cable to TV
Back of RF Modulator
(example only)
Antenna or
Cable TV signal
~ AC MAINS
AUDIO OUT V (Pr/Cr)
U (Pb/Cb)
Y
S-VIDEO IN
VIDEO IN
COMPONENT VIDEO IN
After everything is connected
properly, plug in the AC power cord
to the power outlet.
Never make or change any connections
with the power switched on.
When no disc is loaded, press
STANDBY ON on the DVD Player
front panel,
“
NO DISC” may appear on the
display panel.
OPEN/CLOSE OPEN/CLOSE
MIC LEVEL
STOP STOP PLAY/ PLAY/PAUSE PAUSE
S
TANDBY
-
ON
Connecting the power cord
NO DISC
01-37 MDV434K_Eng_552 04/02/05, 4:14 PM 8