Kenmore 625.348321 User Manual

Page 5

WATER SOFTENER START-UP

SECTION 1

1B.

CHECK LIST OF ALL STEP-BY-STEP GUIDES TO INSTALL

Refer to the Installation Manual, part no.

7159931, for step-by-step guides.

To be sure you have done all the steps to install

the softener, read the following list. Page num-

bers referred to are in the Installation Manual.

Is the house water flow going INTO the soft-

ener valve INLET? Trace piping to be sure.

See pages 10 and 11.

Is the plumbing bypass valve (or 3 valves) set

for SERVICE? Bypass valve(s) should always

remain in soft water service position. Posi-

tion in “bypass” only if needed for softener

repairs. See page 18.

Is the valve drain hose connected the right

way, and without sharp bends or kinks that

could stop or reduce water flow? See page 16.

Is the softener power cable connected to the

transformer, and is the transformer plugged

into an inside, 120V-60Hz electrical outlet?

See page 20.

Be sure to restart the water heater. See page

20.

Note, for installations in the State of Massachusetts:

Plumbing codes of Massachusetts shall be adhered to.

Consult with your licensed plumber.

brass

3--valve

plastic

Bypass

Valves

Water

Heater